ASTM A572. The ASTM A572 specification is the Standard Specification for High-Strength Low-Alloy Columbium-Vanadium Structural Steel for plates used in general construction and structural applications. ASTM A572 includes five grades with specified minimum yield strengths of
ASTM A572 Grade 50, 55, 60, 65 Steel Plates Specification A:Specimen shall comply with Specification of A6/A6M. B:Elongation not required to be determi ed for floor plate. C:For wide flange shapesover 426 lb/ft [634 kg/m], elongation in 2 in. [50 mm] of 19% minimum applies. D:For plates wider than 24 in. [600 mm], the elongation requirement is reduced two percedntage points for Grade 42, 50, and 55 [290,345,and 380], and three percentage points
ASTM A607 - STANDARD SPECIFICATION FOR STEEL, SHEET standard specification for steel, sheet and strip, high-strength, low-alloy, columbium or vanadium, or both, hot-rolled and cold- rolled A description is not available for this item. ASTM A607
ASTM A607-98 [ Withdrawn ] Standard Specification for Steel, Sheet and Strip, High-Strength, Low-Alloy, Columbium or Vanadium, or Both, Hot-Rolled and Cold-Rolled (Withdrawn 2000) standard by ASTM International, 06/10/1998. View all product details
ASTM A653 / A653M - 20 Standard Specification for Steel This specification covers steel sheet, zinc-coated (galvanized) or zinc-iron alloy-coated (galvannealed) by the hot-dip process in coils and cut lengths.
ASTM A787 Tubing - Valmont TubingASTM A787 Type 6 welded mechanical tubing is produced using steel that has been pre-coated with a thin layer of a zinc-aluminum-magnesium alloy coating while in coil form as specified in ASTM A1046. Tubing produced to A787 Type 6 provides a high degree of corrosion resistance and an excellent surface appearance and is a bridge between stainless and hot-dip galvanized finishes.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.. ASTM Standards. A761/A761M Specification for Corrugated Steel Structural Plate, Zinc-Coated, for Field-Bolted Pipe, Pipe-Arches, and Arches. A796/A796M Practice for Structural Design of Corrugated Steel Pipe, Pipe-Arches, and
CARBON STEELCommercial Steel This quality is defined in ASTM Standards A1008 for Cold Rolled, (CS Type A, B, or C) A1011 and A1018 for Hot Rolled and is equivalent to the former Commercial Quality . Sheets of this quality are suitable for applications where bending, moderate forming or drawing may be involved .
In the AISI 1996 Specification the ASTM A446 Standard was In 2001, the ASTM A1008/A1008M and ASTM A1011/A1011M Standards replaced the ASTM A570/A570M, ASTM A607, ASTM A611, and ASTM A715 Standards. ASTM A1003/A1003M was added to the list of Specification Section A2.1. In 2007, the ASTM A1039 Standard was added to the list of Specification Section A2.1. For all grades of steel, ASTM A1039 complies with
ASTM A607 - 98 Standard Specification for Steel, Sheet and Strip, High-Strength, Low-Alloy, Columbium or Vanadium, or Both, Hot-Rolled and Cold-Rolled (Withdrawn 2000) Gathering PDFs Products and Services / Standards & Publications / Standards Products. Products and Services.